Roof Safety Mesh Installation Guide

Avoid storing old roofing material on the roof.

Roof safety mesh installation guide.

Side lap joints can be spaced further apart. 9 2 position of roof safety mesh roof safety mesh shall be positioned in accordance with the following. Develop a system prior to installing the roof cladding to ensure that safety mesh when used is inspected and certified by a competent person as being installed in accordance with the manufacturer s recommendations o. Instead they should transfer it from point of removal to the ground p.

If safety mesh is used ensure it. Staging on the roof surface to spread the loads safety mesh secured under fragile roofing or skylights. Spacing of the fixing will depend upon the type of joint to be sealed. Fasteners in joints with profiled roofing e g.

9 installation requirements 9 1 general the installation of roof safety mesh shall comply with the requirements of clauses 9 2 and 9 3. Complies with the requirements of australian standard as4389 1996 for safety mesh with galvanised coating grade w02z. Longitudinal wire must face down with the cross wires facing up all longitudinal wires need to be wrapped around or through drilled holes in the purlins and tied off with a minimum of. Provides fall protection for roof installers and offers long term fall protection for maintenance and repair workers.

Inspections of roofing contractors naics 238160 rank by number of citations issued categories standard 1 duty to have fall protection 1926 501 2 ladder safety 1926 1053 3 fall protection training requirements 1926 503 4 eye and face protection 1926 102 5 general scaffold requirements 1926 451 6 general safety and health provisions 1926 20. Retains insulation materials and continues to provide protection after roof construction. Appropriate lifting technique for long roof conforms to as nzs 4389 2015 roof safety mesh is installed by a competent person in a safe manner and in accordance with the manufacturer s instructions. A position of mesh where roof safety mesh is required it shall be fitted under the roof sheeting so that it is supported by metal and or timber purlins rafters or roof members that are part of the roof structure.