Roof Truss Support Walls

This means that at the top floor of a house the interior walls may not be supporting the weight of the roof structure and the weight of snow.

Roof truss support walls.

To hold them up until the decking of the roof is placed on top a 12 foot 1 inch by 4 inch piece of lumber is used. Usually trusses are put 24 inches apart. Elements that make a roof truss bearing. A gable truss sits on the end wall of a structure and has vertical studs every 2 feet or 16 inches.

By eliminating interior bearing walls trusses also save the cost of interior foundation walls interior partition top plates and headers. Roof trusses can span much longer distances than joists so if you have a gable roof there is a good chance that it can span between exterior walls and not require an interior bearing wall for support. Engineered roof truss systems may be designed to eliminate the need for load bearing walls or change where the bearing walls are located. Some roof truss types such as stub and dual pitch contain no center and therefore lack central support.

Nearly all types of trusses used in roofs from kingpost and queenpost to bowstring and cambered possess a central support beam. You will need an engineer involved in this since many contractors will tell you anything to get the job. Truss roofs are typically designed to use some interior walls as mid span support to save on costs associated with making the truss larger stronger. Roof trusses support a roof s weight by transferring the weight load downward and outward to the building s bearing walls.

Flat the most economical flat truss for a roof is provided when the depth of the truss in inches is approximately equal to 7 of the span in inches. A gable truss isn t structural and needs a continuous bearing support underneath such as a beam or wall. Structural support usually a beam or wall that is designed by the building designer to carry the truss reaction loads to the foundation.