Roof slope is the amount of change in height as a ration of horizontal distance traveled usually expressed as inches of rise per foot of horizontal run or cm of rise per m of horizontal run.
Roof wall plate position.
This means that from the center of one joist to the center of another there is 16 inches.
Another way when the roof is too large for that or there are not four corners is to use the 3 4 5 method shown here to make sure the corners are at a perfect 90 degrees.
This marks the plumb cut at the inside of the house wall for the notch called a bird s mouth to seat the rafter one the wall plate.
Fixings used to connect the roof structure to the wall plate should be specified according to the roof construction and exposure of the site.
Measure and mark the top plate of the walls on either side of your structure running in line with the proposed roof s ridge every 24 inches.
Where trussed rafter roofs are not subject to uplift a minimum of two 4 5mm x 100mm galvanized round wire nails skew nailed one on each side of the trussed rafter or truss clips fixed in accordance with the manufacturer s instructions are acceptable.
Add the length of the overhang beyond this mark and mark it.
If the new stud is too short it will not support the plate and roof.
Put the rafters into position and then drill a hole through the top of the rafter in line with the middle of the wall plate see red arrow above.
Note the square is turned over.
Step 1 measure top wall plate.
Use the same type lumber as the rotted studs.
Matching the exact length of the studs is vital.
Upper wall plate top plate or ceiling plate upper wall plate which is fastened along the top of the wall studs before the wall is lifted into position and on which the platform of the next story or the ceiling and roof assembly rest and are attached.
38 x 100mm or in accordance with local practice.
They should be fixed firmly to the brick or blockwork underneath.
Step 2 stand the first truss on the end of the wall flush with the outside end of the wall.
When the measurement is equal the plates are square.
A second layer of dimensional lumber is always fastened to the top plates of the erected.
Also sidespike 4 ovals into either side of the rafter again into the top of the wall plate blue arrow above.
Holding the square in the same position as before mark down to the side of the tongue.
The hanging beam reduces the span of the ceiling joists.
The ceiling joists are attached to the top plate and tie the walls of a structure or a room together and supports the ceiling lining of the structure or room.
If the new stud is too long it will push the top plate up and can affect the roof position.
To provide strength and even spacing a hanging beam is nailed to the top of the ceiling joists not shown.
Normally a roof span is the same as the building width between the outer edges of the wall top plates.
The roof joists will need to be spaced at 16 inches on center.
In order to get the right amount of 2 by 6 lumber to use as your roof joists you will need to measure the top wall plate.
Definition of roof slope.
Then knock a 6 nail down through the hole and securely into the wall plate.
