Tack Down Carpet

Step 5 tuck the end of the carpet into the gap between the tack strip and the tile by using a stair tool or a putty knife.

Tack down carpet.

Then you ll be able to grab hold of the carpet and pull it away from all the tack strips like a zipper. If you have tack down carpet in your home it can be hard to remove. Nail the carpet tack strip to the floor using a hammer. Lay two pieces of carpet directly up against one another.

Push the lever down to stretch the carpet taut. Getting rid of it can be simple with the help of an experienced removal service equipped with specialized machinery and skill. Nail each carpet strip to the floor working around the perimeter of. Position a carpet kicker tool 3 inches away from the end of the carpet in the doorway.

Once the carpet is rolled out and installed it has to be tacked down. Lift one corner of the carpet with a pair of pliers and gently tease it free of the tack strip photo 1. Cut the carpet with a slotted blade knife so that it is even with the edge of the tile. The tacks will grip the backing and hold the carpet in place.

Reach in front of the power stretcher to hook the carpet onto the tack strip. Then put the seam tape under the two edges. Then take your seam iron and run it across the tape. Each tack strip is approximately 4 feet long.

It s easy to unravel the fibers. Also be careful not to pull the carpet past doorways where you might break a seam. Wear protective gloves since the tack strips are filled with sharp points. The carpet tack should grip the edges of the carpet through the carpet backing.

This will melt the tape and make it hold the two pieces of carpet together. Step 7 press forward on the knee portion of the tool to stretch the carpet and use a putty knife to tuck the edge of the carpet into the tack strip down in the floor. The metal spiked head should face the doorway and the rubber pad should be near your knee. The installation process is designed to hold the carpet in place for decades making it difficult to get up without the right equipment.

Use the carpet kicker and stretch the carpet over the tacks and past the tack strip by 1 4 inch. Continue along the wall then trim excess with the wall trimmer and tuck the edge underneath the baseboard. Use a scrap board to prevent damage to the baseboard.